16039 Image IMAGE: Proofing receiver already loaded Trendsetter_400/800_Proofing The workstation has launched a proof but the recorder has detected that there is already a receiver on the drum by testing the plate_loc d proofer_status flag. When this flag is 2, the recorder thinks there is a receiver on the drum. The workstation should have unloaded it at the end of the last proof by issuing a WORKSTATION_PROOF_END command but for some reason it didn't. If there is a receiver on the drum, try to unload it from the workstation. If there is not a receiver on the drum this error is possibly a firmware bug. Manually reset the flag. "set state plate_loc d proofer_status 0" Get the monitor log and report it to the responsible firmware developer. Record error message and call Creo Service. Proofing reciever not unloaded. Possible workstation sw error. Check the debug file to see if an END_PROOF command was sent by the workstation ( you will see the command E x where x is the image number ). If not, it is a workstation sw error. If it was sent, investigate why it was ignored. Unload cycle ignored by the recorder. The unload will be ignored if the "set sys load" parameter is 0. This flag should always be 1 in normal operation. Possible firmware error. Proofer_status in plate_loc d table was not cleared when the receiver was unloaded. Check the monitor log to see if the unload was ignored. It's possible that "set sys load " is 0 which prevents the machine from unloading the receiver. ../nvs/sys_cfg_load.xmlNVS: sys load ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:33:29 2008 PST